Home / Basement Waterproofing / Sump Pump Installation
Sump Pump Installation & Replacement in Kansas City, KS
The sump pump is what actually gets water out of your basement. We install reliable primary pumps, add battery backups for storm outages, and replace old pumps before they fail during the rain you need them most.
From inspection to a dry basement
We check your pit, inflow, and discharge route, then build a system sized for your water volume.
Signs your sump pump needs attention
A sump pump has a limited service life, usually around 7 to 10 years. Warning signs include:
- The pump runs constantly, or short-cycles on and off
- It makes grinding or rattling noises, or vibrates hard
- The pit fills up and the pump is slow to catch up
- Visible rust, or the pump is more than about seven years old
- No backup, so an outage during a storm means a flooded basement
- The discharge line freezes or clogs and backs water up
The worst time to find out a pump has failed is during a heavy storm, which is also when the power is most likely to be out.
Why a good sump setup matters here
Kansas City gets intense spring and summer storms that saturate the clay soil fast. When the water table rises, the sump pit fills quickly and the pump has to move a lot of water in a short time. An undersized or worn pump cannot keep up.
Those same storms knock out power, so a pump with no battery backup is offline exactly when it is needed.
A sump system built to keep working
We install a properly sized primary pump in a sealed pit with an airtight lid, a check valve, and a discharge line routed well away from the foundation. For homes that flood in outages, we add a battery backup pump that takes over automatically when the power drops or the primary fails.
- Correctly sized primary pump for your water volume
- Sealed pit and lid to control humidity and radon
- Battery backup pump for storm power outages
- Discharge routed away from the foundation, with freeze protection
- High-water alarm so you know if something is wrong
What goes into the system
Primary pump
A cast-iron or heavy-duty pump sized to your pit and inflow, on a reliable float switch.
Battery backup
A second pump on a deep-cycle battery that runs when the power is out or the primary cannot keep up.
Alarm and check valve
A high-water alarm and a quality check valve so water does not run back into the pit.
How the process works
1. Book a visit
Call or send the form and we set a time to come out.
2. Inspection
We check your pit, inflow, and discharge route, and confirm whether a backup is worth adding for your home.
3. Written plan
A clear explanation, the recommended fix, options, and a written price. No pressure.
4. The work
A pump swap is usually a couple hours. A new pit and full system with backup takes most of a day.
What sump pump work costs
A straightforward pump replacement is a modest job. Cost rises with:
- Replacing just the pump vs. building a new sealed pit
- Adding a battery backup pump and battery
- Rerouting or extending the discharge line, with freeze protection
- Tying the sump into a new interior drain system
- A high-water alarm or WiFi monitoring
We give you options at different price points so you can decide how much protection you want.
Common questions
How much does sump pump installation cost in Kansas City?
How long do sump pumps last?
Do I really need a battery backup?
Where should the sump water discharge?
My pump runs all the time. Is that bad?
Can you install a sump pump where there is not one now?
Related services and reading
Serving Kansas City and the Kansas suburbs
We work throughout Kansas City, KS and the surrounding Kansas communities in Wyandotte, Johnson, and Leavenworth counties.
Get your sump system checked
Free inspection of your pump, pit, and discharge, with options for backup protection.